Page 1 of 1
Errors when I upgraded to Version 3.9
Posted: 17 April 2025, 16:39
by rhsrxs
I upgraded to Version 3.9. I am getting errors. I have attached a screenshot of a simulation (HDA) and not all the unit operations are displaying and errors at the bottom.
Re: Errors when I upgraded to Version 3.9
Posted: 17 April 2025, 17:57
by jasper
Can you insert a compressor into a new document?
Re: Errors when I upgraded to Version 3.9
Posted: 17 April 2025, 18:01
by jasper
If the anwer to that is no, it looks like the compressor did not get registered properly.
In this case, please re-install, or open a command prompt to go to the COCO installation folder, and in the x64 folder, try
For an all users installation, the command prompt must be started As Administrator.