3 PHASE SEPARATOR
Posted: 12 March 2019, 05:16
hi, l modelled a 3 phase separator, and all the light liquid phase went to the heavy phase, while on COCO a gas, 2 liquid phases were formed. See attached!
Not clear on your question. COCO/TEA does not support two liquid phases - you will have to use a different thermodynamic property package for this.
The result at 25C and 1atm is a vapor and a liquid - the middle stream does not have any content on it (zero flow rate). Flash ROUT at 25C and you will see the same.