Page 1 of 1

Information Calculator

Posted: 15 October 2013, 23:42
by wmconlon
I am exposing the mass flow rate of fuel (methane) by a Measure UnitOp and the HHV on a mass basis using a HeatofCombustion UnitOp. I expect to multiply these in an information UnitOp to obtain the Heat Release Rate in Watts.

In the Information UnitOp GUI, I attempt to assign units of Watts to the output by double-clicking on the power. When I type '1' COFE crashes.

Is there another way to assign the units of measure?

Re: Information Calculator

Posted: 15 October 2013, 23:59
by wmconlon
Updated to 2.6.0.8 and it works. Problem solved.

Re: Information Calculator

Posted: 16 October 2013, 06:35
by jasper
Updated yesterday actually, ed@mo-ed.com pointed out the same problem. Glad to hear it works.