3 PHASE SEPARATOR
Moderator: jasper
3 PHASE SEPARATOR
hi, l modelled a 3 phase separator, and all the light liquid phase went to the heavy phase, while on COCO a gas, 2 liquid phases were formed. See attached!
- Attachments
-
- aspen solution.PNG (53.79 KiB) Viewed 8644 times
-
- 3 phase separator.fsd
- (24.7 KiB) Downloaded 968 times
Re: 3 PHASE SEPARATOR
Not clear on your question. COCO/TEA does not support two liquid phases - you will have to use a different thermodynamic property package for this.
The result at 25C and 1atm is a vapor and a liquid - the middle stream does not have any content on it (zero flow rate). Flash ROUT at 25C and you will see the same.
The result at 25C and 1atm is a vapor and a liquid - the middle stream does not have any content on it (zero flow rate). Flash ROUT at 25C and you will see the same.